along the horizontal axis.
5.
Push the projection cone to pop it out (See
4
).
6.
To change the projection slightly to a different angle, turn the
IMAGE ROTATE
wheel (maximum 90 degree left or right).
7.
Press
PROJECTION/IMAGE FLIP
to switch between: bright, dim, very dim and off.
Helpful hints:
–
Turn the projection lens right upside before trying to push it back into the set.
–
In sleep mode, only animation is projected by default. You can also press
PROJEC-
TION/IMAGE FLIP
and
DISPLAY
to project both animation and time.
Warning:
–
The projection light might harm your eye. Please do not look at the projection lens
directly.
USING THE SENSOR TO DETECT OUTDOOR TEMPERATURE (See
3
)
The main unit comes with an outdoor sensor. Using the sensor, the unit is capable
to measure and display outdoor temperature through receiving data trasmitted
from the sensor placed at other location.
1.
Place the sensor in a desired open area. The place must be within 50 meters
away from the main unit. Make sure the sensor is loaded with the batteries.
•
For the first time
using the outdoor sensor and the main unit, press
RESET
located on the sensor back, and
RESET
located in the bottom of the main
unit. Then, the main unit will begin to receive transmission from the sensor.
2.
To update the outdoor temperature from the sensor any time, press and hold
AUTO SCAN
for 5 seconds.
™
The temperature will be updated from the sensor about every 3 minutes.
™
When the outdoor temperature is updating with the sensor searching,
is displayed on the main unit.
To Improve the sensor reception
In case of intermittent/no connection,
•
Slide the
CHANNEL
switch to Channel
2
or
3
, located in the battery com-
partment of the sensor, then repeat the setup connection described above.
•
Reduce the distance between the sensor and the main unit.
