9
2.5.2. ID Remote Control
Set remote control ID number when using several displays.
Press the [
ID
] button and the red LED blinks twice.
1. Press the [
ID SET
] button for more than 1 second to enter the ID
mode. The red LED lights up.
Press the [
ID SET
] button again to exit from the ID mode. The red
LED lights off.
Press the digit numbers [
0
] ~ [
9
] to select the display to be controlled.
For example: press [
0
] and [
1
] for display No.1, press [
1
] and [
1
] for
display No.11.
The available numbers are [
01
] ~ [
255
].
2. If no button is pressed within 10 seconds, it will exit from the ID
mode.
3. If a wrong button is pressed, wait for 1 second until the red LED
lights off and then turns on again, then press the correct digits.
4. Press [
ENTER
] button to confirm your selection. The red LED blinks
twice and then lights off.
NOTE:
• Press the [
NORMAL
] button. The green LED blinks twice, indicating
that the display is under normal operation.
• It is necessary to set up the ID number for each display before
selecting its ID number.