Mechanical Instructions
4.
4.3
Assy/PWB Removal
4.3.1
Metal Back Plate
Caution:
Disconnect the mains power cord before you remove
the metal back plate.
Figure 4-4 Metal back plate
1.
Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution:
do
not
put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2.
Remove all T10 parker screws (1) from the top, centre, and
left and right sides of the back plate.
3.
Remove all T10 tapping screws (2) from the bottom of the
back plate.
4.
Remove the four "mushrooms" (3) from the back plate.
5.
Lift the back plate from the TV. Make sure that wires and
flat foils are not damaged during the back plate removal.
4.3.2
Rear Cover
Figure 4-5 Rear cover
1.
Disconnect all connectors (1) at both Ambient Light
Inverters that go to the Ambient Lights in the rear cover.
2.
Remove all T10 tapping screws (2) around the edges of the
rear cover.
3.
Lift the rear cover from the TV.
4.3.3
Ambient Light Panel(s)
Figure 4-6 Ambient light inverter (left side)
Figure 4-7 Ambient light inverter (right side)
Later models are equipped with two Ambient Light Inverter
panels. For the earlier models with one panel, reference is
made to the FTP2.2x Service Manual for the correct
mechanical instructions.
1.
Disconnect all cables from the Ambient Light Inverter
panel.
2.
Remove all mounting screws (1) from the Ambient Light
Inverter panel.
3.
Take out the Ambient Light Inverter panel.
4.3.4
Power Supply Panel
1.
Disconnect all cables from the Power Supply panel.
2.
Remove all mounting screws from the Power Supply panel.
3.
Take out the Power Supply panel.
4.3.5
SCART3 Panel
1.
Disconnect all cables from the SCART3 panel.
2.
Remove the two mounting screws (7) near the SCART3 at
the connector plate (see figure "Connector plate").
3.
Take out the SCART3 panel.
F_15460_074.eps
140405
1
2
1
1
1
1
1
3
F_15460_073.eps
140405
2
2
2
2
1
F_15460_071.eps
130405
1
F_15460_072.eps
130405
1