Philips 29PT9417, User Manual

Page: 18 / 22

18
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note:
EXT. 1
can handle CVBS and RGB,
EXT. 2
CVBS and Y/C,
EXT. 3
CVBS and RGB. It is preferred to connect
peripherals with RGB output to
EXT. 1
or
EXT. 3
as RGB provides a better picture quality.
If your recorder is provided with the Easylink function, it should be connected to
EXT. 2
to benefit from the EasyLink
functionality.
Recorder
(
VCR
-
DVD
+
RW
)
Connect the aerial cables
1
, 2 and, to obtain the optimum
picture quality, eurocable
3
as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder’s test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable
4
to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 9 You can also connect your decoder directly to
EXT. 1
or
2
with a eurocable.
Other equipment
(satellite receiver, decoder, DVD, games, etc.)
& Connect the aerial cables
1
,
2
and
3
as shown (only if
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable
4
or
5
to one of
the euroconnectors
EXT.1
,
2
or
3
to obtain a better picture
quality.
é Look for the test signal of your peripheral in the same way as
you do for a recorder.
“ Make a selection in the Setup, Source menu, p. 9.
Side connections
Camera or Camcorder
&
Connect your camera or camcorder as shown.
é Connect to
VIDEO
2
and
AUDIO L
3
for mono
equipment. For stereo equipment also connect
AUDIO R
3
.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input
1
and
AUDIO
inputs
3
.
Do not connect cable
1
and
2
at the same time. This may cause
picture distortion !
Headphone
&
Insert the plug into the headphone socket
L
as shown.
é Press
¬
on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.
The headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust the
headphone volume.
CABLE
1
4
2
EXT.
2
3
CABLE
1
2
1
EXT.
2
4
5 3
AUDIO
VIDEO
S•VIDEO
1 2 3
Connect Peripheral Equipment
2195.1 gb 03-03-2003 09:57 Pagina 18