4
Preparation
Surround loudspeakers
There are two surround loudspeakers supplied. One is the active loudspeaker,
including the RF receiver, a power switch, the mains supply, a channel selector,
a red and black connector clip, a left/right surround loudspeaker switch and a
3.5 mm stereo jack to make a wired connection with your TV in case there is
interference or the wireless connection is not possible.The other
loudspeaker is a passive one which has to be connected with the active
loudspeaker with the supplied speaker cable.
•
Set the slide channel switch
1
at the bottom of the active loudspeaker to
channel 1. (In the factory channel 1 has been chosen as the default channel.)
See also Sound Setup, p. 10.
•
Connect the active to the passive loudspeaker with the supplied speaker
cable
2
.
Push the connector clip down, insert one end of the colour coded wire into
the opening of one connector clip and push it up again. Insert the other end
of the same colour coded wire in the same colour connector clip of the
other loudspeaker. Do the same with the other wire in the other connector
clips. Do not insert the wires too far.
•
The Surround sound loudspeakers should always be located behind or to
either side of the listener. If preferred you can also hang the loudspeakers on
the wall.
The maximum distance between the TV and the surround speakers should
not exceed 15 m.
Note: people moving around close to the TV may interfere with the sound
transmission.
•
Set the slide switch
3
to the right if the active loudspeaker is positioned to
the right side of the listener, to the left if it is positioned to the left side of
the listener (seen from the point of view of watching the TV).
•
Connect the active loudspeaker to the mains with the mains cable
4
.
•
Switch on the active loudspeaker with the
POWER
switch
5
.
The red indicator at the front of the active surround speaker shows that the
speaker is in standby.
During sound transmission the indicator turns to green and back to red after
10-15 min. after the TV has been switched off.
To switch the active speaker off, use the
POWER
switch.
(
Insert the mains plug of the TV
in the wall socket having a mains voltage
of 220V-240V.
To prevent damaging the mains (AC) cord which could cause a fire or electric
shock, do not place the TV on the cord.
§
Switch the TV on :
Press the power switch
A
on the front of your TV.
A green indicator on the front of the TV lights up and the screen comes on.
If the indicator is red, press the
- P +
keys on the remote control.
The green lamp blinks every time you press a key on the remote control.
When you switch on your set
for the first time
, the menu
LANGUAGE
automatically appears on the screen. The explanation appears in different languages
one at a time. Choose your own language and press the
OK
key on the remote
control.
5
1
4934.3 gb /05 12-01-2000 14:37 Page 4
