2
1. Important
off immediately and disconnect the
power cord. Then, remove the for-
eign substance or water, and send it
to the maintenance center.
•
Do not store or use the monitor in
locations exposed to heat, direct
sunlight or extreme cold.
•
In order to maintain the best per-
formance of your monitor and use
it for a longer lifetime, please use
the monitor in a location that falls
within the following temperature
and humidity ranges.
•
Temperature: 0-40°C 32-104°F
•
Humidity: 20-80% RH
•
IMPORTANT: Always activate a mov-
ing screen saver program when you
leave your monitor unattended.
Always activate a periodic screen
refresh application if your monitor
will display unchanging static con-
tent. Uninterrupted display of still
or static images over an extended
period may cause “burn in”, also
known as “after-imaging” or “ghost
imaging”, on your screen.
•
"Burn-in", "after-imaging", or "ghost
imaging" is a well-known phenom-
enon in LCD panel technology.
In most cases, the “burned in” or
“after-imaging” or “ghost imag-
ing” will disappear gradually over a
period of time after the power has
been switched off.
Warning
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe “burn-in” or “after-
image” or “ghost image” symptoms
that will not disappear and cannot be
repaired. The damage mentioned above
is not covered under your warranty.
Service
•
The casing cover should be opened
only by qualified service personnel.
•
If there is any need for any docu-
ment for repair or integration,
please contact with your local
service center. (please refer to the
chapter of "Consumer Information
Center")
•
For transportation information,
please refer to "Technical Specifica-
tions".
•
Do not leave your monitor in a car/
trunk under direct sun light.
Note
Consult a service technician if the
monitor does not operate normally, or
you are not sure what procedure to take
when the operating instructions given in
this manual have been followed.