57
Meridian 3
13. DDC Instruction
General
DDC Data Re-programming
In case the main EEPROM with Software DDC which store all factory settings were replaced because a defect
repaired monitor’ the serial numbers have to be re-programmed.
It is advised to re- soldered the main EEPROM with Software DDC from the old board onto the new board if circuit
board have been replaced, in this case the DDC data does not need to be re-programmed.
Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards
Association (VESA). Extended Display Identification Data (EDID) information may be also obtained from VESA.
LPT cable (male to male) 2 VGA cable 12V DC adapter
TPV P/N: N/A TPV P/N: 089G728 GAA DB TPV P/N: ADPC12416BEP
ISP JIG: 715GT034-B PC Monitor
LPT port driver ISP tool EDID
