EN 29
En
gl
is
h
Satellite settings
What you can do
View satellite channels
Note:
Satellite signal is available on certain
models only.
[Search for satellite]
is only available if
the TV supports DVB-S.
To receive satellite channels, connect a
satellite receiver to the SAT connector
on your TV.
LNBs
This TV can receive signals from 4 different
low noise block-down converters (LNBs).
An LNB is mounted at the end pole of the
dish antenna and captures signals from a
satellite.
Install satellite channels
Install satellite channels
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Reinstall channels]
.
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select
[Finish]
, then press
OK
.
Select connection type
While you install satellite channels, you need
to set the connection type. The number of
LNBs on your dish antenna determines the
number of satellite channels you can install.
1. After you select
[Reinstall channels]
,
select
[Settings]
and then press
OK
.
2. Select
[Connection type]
.
3. Select a setting, then press
OK
.
[OneLNB]:
Select if you have only one
LNB.
[DiSeqC Mini (2 LNBs)]:
Select if you
have 2 LNBs.
[DiSeqC 1.0 (3-4 LNBs)]:
Select for 3
or 4 LNBs.
Test signal strength
If a channel or transponder is skipped during
installation, you can test the signal strength of
a satellite or add a new channel.
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Satellite reception test]
, then press
OK
.
3. Select the LNB.
4. If you know the frequency of the
transponder (which can include several
channels), select
[Frequency]
and enter it.
5. Select
[Search]
, then press
OK
.
6. If a new frequency is found, press
[Store]
to add the new transponder with its
channels.
Update satellite channels
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Update channels]
.
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select
[Finish]
, then press
OK
.
Add and remove satellites
You can add or remove satellites at any time,
and install channels from new satellites.
Note:
Before you add satellites, make sure
that the connection type is correct. See
Set
up your TV > Satellite Settings > Install
channels
(Page 29).
1. Press >
[Setup]
>
[Search for
satellite]
, then press
OK
.
2. Select
[Add satellite]
, then press
OK
.
The TV searches for a satellite on the first
free LNB. This can take several minutes. If no
satellite is found, check the antenna
connections and the position of the dish
antenna.
3. If no satellite is found, select
[Restart]
.
If you are satisfied with the added
satellite, install the channels.
4. To install all channels, select
[Install]
. The
installation can take several minutes.
Remove a satellite
1. Press >
[Setup]
>
[Search for
satellite]
.
2. Select
[Remove satellite]
, then press
OK
.
3. Select the satellite you want to remove,
then press
OK
.
