Mechanical Instructions
4.
4.2
Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and
never
only the
display.
Caution:
Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3
Assembly/Panel Removal
Carefully lay the set on a flat, cushioned surface with the
display side facing down and the stand hanging over the edge.
4.3.1
Rear Cover (20”)
Refer to
for details.
Warning:
Disconnect the mains power cord before removing
the rear cover.
1.
Remove the screws [1] that secure the power cable and
rear cover.
2.
At the indicated areas [Blue points] the cover is secured by
clips. Be careful when releasing those.
3.
Lift the rear cover from the TV.
4.3.2
Rear Cover (23”)
Refer to
for details.
Warning:
Disconnect the mains power cord before removing
the rear cover.
1.
Remove the screws [1 and 2] that secure rear cover.
2.
At the indicated areas [Blue points] the cover is secured by
clips. Be careful when releasing those.
3.
Lift the rear cover from the TV.
4.3.3
Rear Cover (28”, 32”, 40”)
Refer to
Warning:
Disconnect the mains power cord before removing
the rear cover.
1.
Remove the screws [1] at the bottom of the rear cover.
2.
Remove the screws [2] that secure the back inputs area.
3.
Remove the screws [3] that fixate the stand and remove
the stand.
4.
At the indicated areas [Blue points] the cover is secured by
clips. Be careful when releasing those.
5.
Lift the rear cover from the TV.
Figure 4-6 VESA bolts removal
Figure 4-7 Rear cover removal (20”)
19421_100_1
3
0514.ep
s
1
3
0514
× 4
1
4 × 12
1
19710_105_140409.ep
s
140409