Philips 2000 PURO/VAPORE, Service Manual

Page: 41 / 67

PHI 2000 PURO/VAPORE 05 SERVICE MODE
7/14
5.2 Test Mode PHI 2000 Vapore
The machine enters in test mode by moving the knob in the Water position
As long as the COFFEE short button is pressing the machine shows the Led Calc-Clean, Led Activity,
Led Alarm, Led NoWater, Led DoubleCoffee, flashing with rotation.
When the COFFEE short button is release the machine pass to the first level of the test.
There are 4 different level, in each level the coffee-machine can execute different commands:
Level 1: The machine can test the input signal:
a) Microswitch present of the brewing unit
b) Microswitch present of the dregdrawer
c) Microswitch door closed/opened
d) Button Short Coffee
e) Button Long Coffee
f) Button ON-OFF
g) Photosensor Water
h) Photosensor Steam (only in Middle-TOP model)
Level 2: The machine can test the loads in low voltage:
a) Brewing unit (24V DC)
Level 3: The machine can test the Pump in high voltage:
a) Pump (120-230V AC)
Level 4: The machine can test the Heater load in high voltage:
a) Heater (120-230V AC)
Level 5: The machine can test the Grinder load in high voltage:
a) Grinder (320V DC)
and then connecting the machine to the plug
then pushing the COFFEE short button
ON/OFF button
Long Coffee button
Short Coffee button
Water Position Water Position
Double Coffee Led
Activity Led No water Led Alarm Led
Descaling Led
This document describes the test
mode of XS PH Vapore machine.
This application is used in order to
test the machine in its mechanics
and electronic components.