EN-10
Connect the antenna cable
3.3
Connect the outside antenna or cable network
to the
TV (75Ω)
socket at the back of the TV
set.
The antenna socket (75 OHM - VHF / UHF /
cable) can be used for connecting an external
antenna or other equipment fitted with a
modulator (video recorder, satellite receiver,
etc.).
We recommend that you do not connect other
equipment (video recorder, satellite receiver,
etc.) to your TV set to begin with, so as not
to complicate the set-up procedure with the
additional steps involved. Connect them when
you have finished setting up the programs.
Connect the mains cord
3.4
Connect the power cable to a mains socket.
Warning:
B
Your TV set must be connected
to an AC supply, not to a DC supply. If the
plug is detached from the cable, do not,
under any circumstances, connect it to a
mains socket, because there is a risk of
electric shock.
Note
D
The picture is for illustration only. The
location of the mains connector varies
according to TV model.
Insert remote control
3.5
batteries
Slide the battery cover off the back of the
1.
remote control.
Insert the two supplied batteries (Size AAA,
2.
Type LR03). Be sure the + and - ends of the
batteries line up with the markings inside
the case.
Slide the cover back into position.
3.
Precautions on using batteries:
Use only the specified type of battery.
•
Do not mix new and used batteries.
•
Do not use rechargeable batteries.
•
Do not expose batteries to excessive heat,
•
throw them in a fire, recharge them or try
to open them. This could cause them to
leak or explode.
Remove the batteries from the remote
•
control if you are not using it for a long
period of time.
