Philips 192E2SB2/10, Service Manual, Page: 65 / 86

ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ˃ˁ˄ 192E2SB2 18.5” Wide WXGA LCD Monitor
2010/08/19 PHILIPS 13 of 26
192E2SB2 LCD 65
General Product Specification
3.14.1.4 User Operation Procedure
A. 3 different modes are switched to next in the sequence from 1 to 3 then back to 1 while
pressing this button: 1) Standard 2) Internet 3)Game. The default setting is ‘Standard”.
B. The FOS optimization will be changed in real time by which profile to be scrolled, users
don’t need to confirm to enable.
C. The SmartImage Lite OSD will remain on screen for 5 seconds after user last action. Or
user can also press [MENU] to close the Smart Image OSD immediately.
D. Except using [MENU] button to scroll down profile. If Smart Image OSD already launched
onscreen. User is allowed to use up/down key to choose profile and press [MENU] to confirm
selection and close the Smart Image OSD.
E. If the model has multiple inputs including VGA , DVI each input has their own set of
profiles. When user switch input, the profile to be applied will also change.
F. Each input can memorize their individual “SmartImage Lite” profile status.
For example, SmartImage is on with “Game” profile at VGA input, when switch to DVI input, the
Smart Image will revert to previous profile of DVI.
In the input switching process the “SmartImage” OSD will also show up to present which profile is
selected if “Smart Image” is enabled at that input.
The Smart Image status will also be stored after the monitor is resumed from AC on/off or power
switch on/off.
3.14.1.5 Linkage between Smart Image OSD and main OSD
A. Settings within main OSD have linkage with Smart Image OSD.
i.
Brightness
ii.
Contrast
iii.
Color Temperature
B. Because each preset profiles will define default setting of these 3 parameters. Users
can understand what is the value of that in preset profile by open the main OSD.
C. When any SmartImage Lite profile had been enabled. The parameters in main OSD
are still available for user to adjust. But these adjustments are temporary only. If users
switch to another profile and then go back. The setting in main OSD will show preset
values of that SmartImage profile enabled.