background image

                                                           

                                                        

Disposal

This marking indicates that this product should not be disposed with 
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal, 
recycle it responsibly to promote the sustainable reuse of material 
resources. To return your used device, please use the return and 
collection systems or contact the retailer where the product was 
purchased. They can take this product for environmental safe recycling.

Philio Technology Corporation
8F., No.653-2, Zhongzheng Rd., Xinzhuang Dist., New Taipei City 24257, Taiwan
www.philio-tech.com

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed   and   used   in   accordance   with   the   instructions,   may   cause   harmful
interference   to   radio   communications.   However,   there   is   no   guarantee   that
interference will not occur in a particular installation.   If this equipment does cause
harmful  interference   to   radio   or   television   reception,   which   can   be   determined   by
turning   the   equipment   off   and   on,     the   user   is   encouraged   to   try   to   correct   the
interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This  device   complies  with   Part   15   of   the   FCC  Rules.   Operation   is  subject   to  the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.

 

FCC   Caution:  Any   changes   or   modifications   not   expressly  approved   by  the   party
responsible for compliance could void the user's authority to operate this equipment.

 

This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Warning

Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection   facilities.   Contact   your   local   government   for   information   regarding   the
collection  systems  available.   If   electrical   appliances are   disposed  of   in   landfills  or
dumps, hazardous substances can leak into the groundwater and get into the food
chain, damaging your health and well-being.

When replacing old appliances with new once, the retailer is legally obligated to take
back your old appliance for disposal at least for free of charge.

4

Summary of Contents for PAT12

Page 1: ...d in any Z Wave network with other Z Wave certified devices from other manufacturers All non battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network The table below lists an operation summary of basic Z Wave functions Please refer to the instructions for your Z WaveTM Certificated Primary Controller to access the Setup function an...

Page 2: ... mode the switch is in view from the LED for identification State Type LED Indication No node ID Under normal operation when the Switch has not been allocated a node ID the LED flashes on and off alternately at 30 second intervals By pressing On Off button it will stop flashing temporarily Learning When PAT12 is in learning mode If the learning code is successful the LED will flash slowly Programm...

Page 3: ...tarting the update please remove the front case of the device otherwise the hardware check will fail Let the controller into firmware update mode and press the front tamper key once to start the update After firmware download is completed the LED light will flash intermittently Overview Specification Rated Voltage DC5V from USB Range Minimum 40M in door and 100M in outdoor line of sight Operating ...

Page 4: ... by turning the equipment off and on the user is encouraged to try to correct the interference by one of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help...

Reviews: