Air Quality Multi Sensor PAT05
The PAT05 multi-sensor is a device that allows you to check the air quality in your
home. The PAT05 Multi-sensor is easy to use and very convenient for your home. Just
set the sensor on the wall of the rooms you would like to control, and you are ready to
go. Moreover, the PAT05 can be integrated to other Z-Wave certified devices, and
controlled with Philio app “Home Mate 2.” You can now protect your family and make
sure there are no gas leaks that can harm those you love the most. Set up your
PAT05 to send regular notifications and take control even when not at home.
This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-
Wave Plus messages to communicate to other security enabled Z-Wave Plus
products. Z-Wave
TM
enabled devices displaying the Z-Wave
TM
logo can also be used
with it regardless of the manufacturer, and ours can also be used in other
manufacturer’s Z-Wave
TM
enabled networks.
The product supports Over The Air(OTA) feature for the products firmware upgrade.
This product can be included and operated in any Z-Wave
TM
network with other Z-
Wave
TM
certified devices from other manufacturers and/or other applications. All non-
battery operated nodes within the network will act as repeaters regardless of vendor
to increase reliability of the network.
The device adopt the Z-Wave
TM
500 series chip, when your Z-Wave
TM
network system
is all made by Z-Wave
TM
500 series devices. The network system will have the
advantages as below.
Notice:
Once you have completed the setup process, Please allow for a 7-Day settling period
for the sensors to adjust to their new environment and to observe a typical cycle of air
quality, based on your activity within a 1 week period.
Add to/Remove from Z-Wave
TM
Network
There are one tamper keys in the device, in the back side. Can be add, remove, reset
or association from Z-WaveTM network.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z-WaveTM Certificated Primary Controller to access the
Setup function, and to Add/Remove/associate devices
Notice
: Including a node ID allocated by Z-Wave
TM
Controller means “
Add
” or
“
Inclusion
”. Excluding a node ID allocated by Z-Wave
TM
Controller means
“
Remove
” or “
Exclusion
”.
Function
Description
Add
(Inclusion)
1.
Have Z-Wave
TM
Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the
inclusion mode.
1