Adding to Z-Wave
TM
Network
I
n the front casing, there is an On/Off button with LED indicator which is used to
toggle switch on and off or carry out inclusion, exclusion, reset or association.
When first power is applied, its LED flashes on and off alternately and repeatedly
at 0.5 second intervals. It implies that it has not been assigned a node ID and start
auto inclusion.
Auto Inclusion
The function of auto inclusion will be executed as long as the switch does not
have Node ID and just plug the switch into a wall outlet.
Note:
Auto inclusion timeout is 2 minutes; during which the node information of
explorer frame will be emitted once several seconds. Unlike “inclusion” function
as shown in the table below, the execution of auto inclusion is free from pressing
the On/Off button on the Switch.
The table below lists an operation summary of basic Z-Wave functions. Please re-
fer to the instructions for your Z-Wave
TM
Certificated Primary Controller to ac-
cess the Setup function, and to Add/Remove/Associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not al-
locate a node ID to the Switch.
LED 2-second on, 2-second
off
Add
1. Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing On/Off button three
times within 2 seconds will enter
inclusion mode.
Remove
1. Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
2. Pressing On/Off button three
times within 2 seconds will enter
exclusion mode.
3.Node ID has been excluded.
LED 2s On, 2s Off (Enter
auto inclusion)
Reset
1.
Pressing On/Off button three
times within 2 seconds will enter
inclusion mode.
Use this procedure only in
the event that the primary
controller is lost or other-
wise inoperable.
2.
Within 1 second, press On/Off
button again for 5 seconds.
3.
IDs are excluded.
LED 2s On, 2s Off (Enter
auto inclusion)
Association
1.
The PAN38 is an always listen-
ing Z-Wave device, so associa-
tions may be added or removed
by a controller at any time. Or If
your controller requires to have
the PAN38 send a 'node infor-
mation frame or NIF for associa-
tions, then pressing the On/Off
button three times within 2 sec-
onds will cause the PAN38 to
send its NIF.
