Philco PTB 94 FW, Manual

Page: 21 / 146

Copyright © 2019, Fast ČR, a. s. Revision 07/2021
EN - 19
Defrosting in fresh food storage compartment
• It is automatically controlled by switching the temperature regulator on or off so that there is no need of
operation of defrosting. Water from defrosting will be drained into an drip tray through a drain pipe at the
back of the fridge automatically.
Go out of use for a long time
• Remove all refrigerated packages.
• Switch off the appliance by turning the temperature regulator to position “0”.
• Remove the mains plug or switch off or disconnect the electricity supply.
• Clean thoroughly (see section: Cleaning and Care).
• Leave the door open to avoid the build up of odors.
Note:
lf the appliance contains freezer compartment.
Changing the LED light
WARNING
If the LED light is damaged, PLEASE DO NOT CHANGE IT YOURSELF!
Changing the LED light carry out by inexperienced persons may cause injury or serious malfunctioning.
lt must be replaced by a qualified service technician in order to avoid a hazard. Contact your local Service
Center for help.
Before changing the LED light, switch off the appliance and unplug it, or pull the fuse or the circuit breaker.
• LED Light data: 220-240 V, max. 1.5 W.
• To switch off the appliance, set the temperature regulator to position “0”.
• Unplug the mains plug. To change the LED light, undo the screw.
• Press the LED light cover as shown and slide it backwards.
• Change the defective LED light.
• Refit the LED light cover and the screw.
• Put the refrigerator back into operation.
Thermostat knob
Led light (inside)
Lampshade