EN - 20
04/2016
Copyright © 2016, Fast ČR, a. s.
PART 10: WHAT TO DO IF...
WARNING!
Before troubleshooting, disconnect the power supply. Only a qualifi ed electrician or other personnel
must carry out the troubleshooting that is not in the manual.
IMPORTANT!
Repairs to the appliance may only be performed by competent service engineers. Improper repairs
can give rise to signifi cant hazards for the user. If your appliance needs repairing, please contact your
specialist dealer or your local Customer Service Center.
Problem
Possible cause
Solution
Appliance dose not work.
Appliance is not switched on.
Switch on the appliance.
Main plug is not plugged in or is
loose.
Plug the appliance into the electrical
socket.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Outlet is defective.
Defective parts need to be repaired
by an electrician.
Appliance cools too much.
Temperature is set too cold.
Turn the temperature regulator to
a warmer setting temporarily.
The food is too warm.
Temperature is not properly
adjusted.
Please refer to the “Initial Start Up”
section.
Door was open for an extented
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulator to
a warmer setting temporarily.
The appliance is near a heat source.
Please refer to the “Installation
Location” section.
Interior lighting dose not
work.
Light bulb is defective.
Please look in the “Changing the
Light Bulb” section.
Heavy build-up of frost,
possibly also on the door seal.
Door seal is not air-tight (possibly
after reversing the door) .
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time,
shape the warmed door seal by
hand so that it sits correctly.
Unusual noises.
Appliance is not level.
Readjust the feet.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
If necessary, carefully bend the
component out of the way.
The compressor dose not start
immediately after changing
the temperature setting.
This is normal, no error has occurred. The compressor starts after a period
of time.
Water on the fl oor or storage
shelves.
Water drain hole is blocked.
Refer the “Cleaning and Care”
section.
