14
PHILCO
time to prevent overloading of
your power line.
Turning On
• Plug the power cable of device
into the socket. Convector will
beep and blue LED will turn on
control panel. Device is in stand-
by mode, it does not heat.
Press On/Off button to start device.
Display will show actual tempera-
ture in the room.
Note:
When turned on for the first
time this device uses full power
of heating element.
Selection of Operating Mode
(Full/Half power)
To select operating mode (full or half
power) press button 4.
The following indicator will be dis-
played:
LO – half power,
HI – full power.
Temperature Setting
• Press On/Off button again to
set to a desired temperature.
Display will show temperature
settings. Use the buttons «» or
«V» for temperature setting. Every
time these buttons are pressed
the temperature is increased or
decreased by 1°С, respectively.
The maximum temperature is 30°С
and the minimum temperature is
5°С. The temperature will continu-
ously increase or decrease by 1°C
every 0.5 sec if you press and hold
buttons « » or «V». If the buttons
are not pressed during 5 seconds
device will operate in normal mode.
Actual room temperature will be
displayed on the screen.
Setting Power-Off Timer
• Three times press button «On/
Setting» to set timer. Time will be
displayed and timer indicator will
blink on display. Press buttons
« » or «V» to set timer. Timer
time setting ranges from 1 to
24 hours. Time will continuously
increase or decrease by 1 hour
every 0.5 sec if you press and
hold buttons « » or «V». Timer
preset time should be 0 hours.
When timer indicator is continu-
ously lit system start time counter
in accordance with the last set
value if no buttons are pressed
within 5 seconds after time was
set.
System resets to new time each
time the buttons « » or «V» are
pressed for timer setting. When set
time expires system will automat-
ically turns the heater off without
tone signal turning on standby
mode.
Shutdown
• Press and hold On/Off button for
3 seconds when device runs in
