Phil & Teds LATCH BASE, Instructions Manual

Page: 19 / 40

Instructions
• Push down on the front of LATCH base and pull the strap
to tighten LATCH base against the vehicle seat. CHECK to
make sure LATCH base is secure by holding both sides of
the LATCH base near the LATCH strap and moving it from
side to side and front and back. The LATCH belt should not
loosen and the LATCH base should not move easily. The
LATCH base should not move more than 1 inch (2.5 cm)
from side to side or front to back.
• Close the lock-off over the LATCH belt until it clicks into
place.
• Attach the infant car seat into the LATCH base until you
hear a click. Lift up on the handle of the infant car seat to
make sure that it is securely attached in the LATCH base.
If the infant car seat does not latch securely into the
LATCH base, CHECK to make sure green is visible on
the indicators before installing the infant car seat onto the
LATCH base. If green is NOT visible pull up on red release
handle. ALWAYS lift up on the infant car seat to check that it
is securely attached to the LATCH base.
3
3
4
5
4
5