Phihong DC EVSE 60KW, User'S Manual & Installation Instructions

Page: 49 / 58

6. Maintenance
•
The DC Fast Charger is cooled by forced air. Please keep charger in a ventilated
location and do not block the air vents of the DC Fast Charger.
•
Please clean or replace the air filters regularly to ensure the DC Fast Charger
works properly.
•
Please keep the exterior of DC Fast Charger clean at all times and do not spray
water directly at the DC Fast Charger.
•
If there is water intruding into the DC Fast Charger then please cut off the power
source immediately and contact the DC Fast Charger provider for repair.
•
Please make sure the charging connector is returned to the holder of the
charging connector after charging to prevent damage.
•
If there is damage to the charging connector, charging cable or holder of the
charging connector then please contact the DC Fast Charger provider.
•
When using the DC Fast Charger please handle properly. Do not strike or scrape
the cabinet or touch screen.
•
If the enclosure or touch screen is broken, cracked, open or shows any other indi-
cation of damage then please contact the DC Fast Charger provider.
6.1 General Maintenance
WARNING:
Danger of electrical shock or injury. Turn OFF power at the
panelboard or load center before working on the equipment or remov-
ing any component. Do not remove circuit protective devices or any
other component until the power is turned OFF.
•
Disconnect electrical power to the DC Fast Charger before any maintenance work
to ensure it is separated from the supply of AC mains. Failure to do so may cause
physical injury or damage to the electrical system and charging unit.
46