150Mbps Wireless N Router
www.phicomm.com
2
Chapter 1: Introduction
complete, the LED is continuously lit.
WLAN LED: The Wireless LED lights up when the wireless feature is enabled. It flashes when the
Router sends or receives data over the wireless network.
Wi-Fi Protected Setup (WPS) LED: If you have client devices (such as wireless adapters) that
support Wi-Fi Protected Setup, then you can use the Wi-Fi Protected Setup button to
automatically configure wireless security for your wireless network. To use Wi-Fi Protected Setup,
refer to the section of Wi-Fi Protected Setup.
WAN: The WAN LED lights up when there is a connection made through the WAN port. It flashes
to indicate network activity over the WAN port.
LED (1~4): These LEDs are corresponding with the LAN ports on the rear panel. The LED is
continuously lit when the Router is connected to a device through that port. It flashes to indicate
network activity over that port.
LED
Status
Description
POWER
On
Power is on
Off
Power is off
WLAN
On
The wireless function is enabled
Off
The wireless function is disabled
Blinking
Sending or receiving data over wireless network
WPS
Off
WPS function is disabled
Blinking
A wireless device is connecting to the network by WPS function. This process will
last in the first 2 minutes
On
A wireless device has been successfully connected to the network by WPS function
WAN
On
WAN port is connected
Off
WAN port is unconnected
Blinking
Data is transmitting
LAN
(Port 1-4)
On
LAN port is connected
Off
LAN port is unconnected
Blinking
Data is transmitting
