5
TAPE 1. Wall Hanging
Step 1:
Select the wall location where you want to hang your electric heater.
Use the bracket(
Part No.8
) as a table template to draw a horizontal line using a level
and mark 4 drill holes for the 4 anchor screws.
Note: The holes are for mounting of heater and it shall be level so that the heater can
be mounted properly and leveled. See
Fig. A
Step 2:
Drill 4 holes 8 mm (5/16in) in diameter and 43mm (1.7in) deep on the marked
locations. Clean the holes from dust and install the wall anchors into the holes, then
gently tap them into place with a hammer until the flange of the wall anchor is flush
with the wall surface. See
Fig. B
.
Step 3:
Secure the mounting bracket to the wall anchors using the 4 anchor screws
as shown in
Fig. C
.
