MJPEG IP Camera User’s Guide
79/94
Appendix C: Troubleshooting &
Frequently Asked Questions
Question
Answer or Resolution
Features
The video and audio
codec is adopted in the
MJPEG IP Camera.
The MJPEG IP Camera utilizes JPEG compression to
providing high quality images. JPEG is a standard for image
compression and can be applied to various web browsers
without the need to install extra software.
The audio codec is ADPCM compression.
The maximum number
of users access MJPEG
IP Camera
simultaneously.
The maximum number of users is depend on the total
bandwidth accessed to MJPEG IP Camera from clients. The
data throughout of MJPEG IP Camera is around 5~6Mbps.
Therefore, the maximum number of connected clients is
varying by settings of resolution and frame rate. Obviously,
the performance of the each connected client will slow down
when many users are logged on.
The MJPEG IP Camera
can be used outdoors or
not.
The MJPEG IP Camera is not weatherproof. It needs to be
equipped with a weatherproof case for outdoors using.
However, equipped with a weatherproof case will disable the
audio function of MJPEG IP Camera.
Install MJPEG IP Camera
Status LED does not
light up.
• Check and confirm that the standard AC adaptor, included
in packaged, is used. Secure the power connector and re
power it on again.
• If the problem is not solved, the MJPEG IP Camera might
be faulty. Contact your dealer for further help.
The network cabling is
required for the MJPEG
IP Camera.
The MJPEG IP Camera uses Category 5 UTP cable allowing
10 and/or 100 Base-T networking.
The MJPEG IP Camera
will be installed and work
if a firewall exists on the
network.
If a firewall exists on the network, port 80 is open for ordinary
data communication. The MJPEG IP Camera uses port
80(default) only. This port (or the port you specify from the
Configuration screen if you change the default port) needs to
be opened on the firewall.
The username and
password for the first
time or after factory
default reset
Username =
admin
and leave password blank.
Note that it’s all case sensitivity.
Forgot the username
and password
Follow the steps below.
1.
Restore the factory default setting by press pressing and
holding down more than 8 seconds when power on