MJPEG IP Camera User’s Guide
76/94
Appendix A: Restore Factory
Default Settings
There is a button hidden in the pinhole above the Alarm I/O connector. It is used to
restore the factory default settings. Sometimes restarting the MJPEG IP Camera will
make the system back to a normal state. If the system still got problems after reset, user
can restore the factory default settings and install it again.
Restore the MJPEG IP Camera:
1. Power off the MJPEG IP Camera.
2. Insert the paper clip or other tool and press and hold the button down
continuously.
3. Power on the MJPEG IP Camera again.
4. Wait at least 8 seconds and release the tool. Then the MJPEG IP Camera has
been restored to default settings.
5.
Note:
Restoring the factory default setting will lose the all previous settings forever. User
needs to run the IP Finder program to search the MJPEG IP Camera and configure it to
let the MJPEG IP Camera work properly again.