PhD Solutions PHD-EXC-505-HDTL-RX, Operation Manual, Page: 8 / 18

4 4
6.2 Receiver Front and Rear Panels
CAT5e/6 IN DC 5V
CAT5e/6 to HDMI
with IR
HDMI OUT IR2 OUT IR1 IN
RECEIVER
CAT5 e/6 IN DC 5V
CAT5e/6 to HDMI
with IR
HDMI OUT IR2 OUT IR1 IN
RECEIVER
4 5 1 2 3
1
DC 5V
Plug the 5V DC power supply into the unit and connect the
adaptor to an AC outlet.
2
CAT5e/6 IN
Connect to the Transmitter unit with a single CAT5e/6/7 cable
for transmission of all data signals . The yellow LED will illuminate
when both Transmitter and Receiver are connected together with
power supply. The green LED will illuminate when the power supply is
connected to the device.
3
IR1 IN/Extender
Connect to the supplied IR Extender cable for IR signal reception
and transmission to IR1 OUT. Ensure that remote being used is within
the direct line-of-sight of the IR Extender.
4
HDMI OUT
Connect to a HDMI equipped TV/monitor for display of the HDMI
input source signal.
Note: If the connected TV/monitor support only 8bits but the input
source signal contain 10/12bits it may cause no signal display.
5
IR2 OUT/Blaster
Connect to the supplied IR Blaster for IR signal transmission to the
display side from IR2 IN's IR signal. Place the IR Blaster in direct line-
of-sight of the equipment to be controlled.
Plug the 5V Desktop Power Supply Unit with power cord into the
unit and connect to an AC wall outlet for power.