41
SPECIFICATIONS
Product name
CO
2
Incubator MCO-80IC
External dimensions
W986 mm x D853 mm x H2,040 mm (without caster; H1,975 mm)
Internal dimensions
W806 mm x D693 mm x H1,524 mm
Interior volume
851 L
Exterior
Painted steel
Interior
Stainless steel containing copper
Outer door
Double glass with door heater
Outer door latch
Tray
5 trays made of stainless steel containing copper
W776 mm x D659 mm x H10 mm, Maximum load; 30 kg/tray
Access port
Inner diameter; 40 mm, Two locations, each on both sides
Insulation
Slab board
Heater
Main heater: 600 W, Water reservoir heater: 211 W, Door frame heater: 125 W,
Flange heater: 250 W, Glass heater: 150 W
Humidifying system
Normal mode: Natural evaporation with humidifying water
High humidity mode: Heated evaporation with humidifying water
Temperature controller
PID control system
Temperature display
Digital display
CO
2
controller
PID control system
CO
2
density display
Digital display
Air circulation
Fan assisted
Air filter
0.3
μ
m, Efficiency; 99.97 % or more
Water level sensor
Thermal type
Alarm
High/Low temperature alarm, CO
2
density alarm, Upper limit temperature alarm
Door alarm
Remote alarm contact
Allowable contact capacity: DC 30 V, 2 A
CO
2
inlet connection
4 mm to 6 mm diameter tube
CO
2
inlet pressure
0.1 MPa(G) (1.0 kgf/cm
2
(G), 14.5 psi(G))
Accessories
5 trays, 5 sets of tray support, 1 gas tube, 2 tube bands, 1 drain tank (6.5 L)
Power source
Single phase, 220 V-240 V, 50 Hz/60 Hz
Weight
275 kg
Optional accessory
Gas auto changer (MCO-80GC)
Tray (MCO-80ST) same tray as the attached one including 2 tray supports
Roller bottle rack mount (MCO-80RBS)
Small door (MCO-80ID), UV system set (MCO-80UVS),
Auto water supply system (MCO-80AS), Interface board (MTR-480)
Data acquisition system (MTR-5000), Interface board (MTR-L03)
Note
: Refer to the updated catalog when ordering an optional component.
Designs and specifications are subject to change without notice.
