45
44
Connecting a GPS/IMU
Connecting a Phase One camera to a GPS/IMU involves three
steps:
• Physical connection of the camera to the GPS
• Configuring the camera
• Configuring the GPS/IMU
In order to facilitate communication between your Phase One
aerial camera and a GPS receiver, the parameters in your GPS
receiver and camera must match.
Note: The GPS receiver must use the same baud rate as the
camera (9600, 19200, 57600 or 115200).
A comprehensive guide to connecting Phase One aerial
cameras with a GPS receiver is available for download from
http://industrial.phaseone.com/downloads.
Connecting an HDMI Cable to an
iXU-RS 1000/iXU 1000/iXU 150
To connect an HDMI cable to an iXU 1000/iXU 150 camera:
1.
Remove the rubber cover of the HDMI port.
2.
Insert an HDMI cable into the HDMI port of the iXU camera.
3.
Connect the other end to a monitor or other device.
Connecting to a Host Controller with iX Link
The iXU-RS/iXU-R/iXU camera can be connected to a host
controller enabling you to control the camera and capture
images. Images are sent directly to a CompactFlash card.
In order to work with a host controller, use the Phase One
proprietary iX Link protocol. iX Link is a Phase One protocol
of sending and receiving data, and sending commands to an
iXU-RS/iXU-R/iXU camera from an external controller using
RS232.
To use iX Link with your iXU-RS/iXU-R/iXU camera, you need
to:
• Activate iX Link.
• Program the controller device you are using to transmit and
receive the iX Link commands.
See the iX Link Programming Guide, which contains the
application programming interface (API), which is needed to
program your controller. It is available from the Downloads
section of http://industrial.phaseone.com.