iX Controller MK 5 Installation and Operation Guide
4. Connecting Cables and Peripherals
Page 14 of 36
4.4
iX Controller MK 5 to Camera USB 3.0 Cables
The iX Controller MK 5 to camera USB cable (supplied with each camera) transfers control data from the iX
Controller MK 5 and the camera, and images from the camera for storage in the iX Controller MK 5.
To connect iX Controller MK 5 to camera USB 3.0 cables:
1.
Using a 1.5 mm hex key, remove all four screws securing the left USB 3.0 cable bracket to the iX
Controller MK 5.
2.
Connect up to six USB cables as required to the left USB 3 ports.
3.
Place the USB 3.0 cable bracket in place on the iX Controller MK 5 and secure all four screws using the
1.5 mm hex key.
4.
Connect the other end of each USB 3 cable to a Phase One aerial camera.
4.5
Monitors
Phase One recommends ordering and using the pilot and operator monitors available from Phase One. The
monitors are supplied with the following cables for connection to the iX Controller MK 5:
•
iX Controller MK 5 to pilot monitor cable (75021000)
•
iX Controller MK 5 to operator monitor cable (75022000)
4 screws
