IN
4
[SPEAKER INSTALLATION IN A SHEETROCK CEILING]
For proper connection and therefore full enjoyment of your new Phase
Technology speakers, we encourage you to read this owners’ manual
thoroughly, even if you are very familiar with installing speakers.
Speaker placement is very subjective. Placement follows the guidelines
for the developers of in-ceiling speakers, yet is also guided by personal
preferences. The proper spacing, location and adjustment of in-ceiling
speakers are critical for complete enjoyment of your new speakers.
This manual covers these topics thoroughly.
STEP 1
: Choose the appropriate mounting location for each speaker.
NOTE:
When deciding upon a location, consider the following:
• Be certain your speaker wires can be run to or are accessible from
these locations.
• Make certain the wall or ceiling material is sturdy enough to support
the weight and vibration of the speakers.
• It is recommended that our pre-construction rough-in brackets
(part
number RB-21 for CI6.1 & CI6.2, RB-22 for CI7.3)
be used
whenever possible in new construction.
• Be certain the area behind the speaker is free of obstacles such as
wall studs, electrical wiring, pipes, etc.
• Each speaker should be positioned properly, relative to the listening
area for good coverage.
• Audio performance and room-to-room isolation will be improved if
there is some fiberglass insulation placed loosely behind the speaker.
STEP 2:
Using the supplied cutout template, carefully mark the area
to be cut out.
(Fig. 1)
Using a drywall knife or saw, cut a hole in the
drywall and prepare the speaker wires for connection to the speaker
terminals.
STEP 3:
Connect the speaker wires to the spring-loaded input terminals
(Fig. 2)
on the rear of the speaker, making sure no loose strands are
exposed. If connecting the CI6.2 X, see
“Wiring Options for the CI6.2
X”
.
STEP 4:
Carefully place the speaker in the hole cut into the ceiling.
Loosen the clamping screws one turn (counter clockwise) to release
the clamp
(Fig. 3)
. Next, tighten all four speaker clamp screws evenly
to secure the speaker to the wall. It is best to tighten each screw with
the same amount of force (torque). clamping screws are indicated by
an arrow cast into the baffel.
CAUTION: DO NOT OVER-TIGHTEN.
STEP 5:
Using some familiar source material, listen to the tweeter’s
balance with the level control in each of its three positions to find your
favorite tonal balance.
STEP 6:
Carefully replace the grille by pressing it onto the speaker
(Fig. 4)
. The grille will snap into place using magenets. Enjoy!
_
[FIG. 1]
[FIG. 2]
[FIG. 3]
[FIG. 4]
MOUNTING DEPTHS
CI6.1 X & CI6.2 X:
4.375” D
CI7.3 X: 5” D
HOLE DIAMETERS
CI6.1 X & CI6.2 X:
7.875” DIA
CI7.3 X: 9.625” DIA
