11
2.1.3
AC Power Supply Input Installation
Step 1: Check the Power Supply Type and Voltage
Make sure that the mains power supply is a 3 phase AC power supply, and its voltage is 150 ~ 500
Vac.
Step 2: Install the Filter
Connect the filter to the AC power supply. Then, connect one end of the AC power supply cable to
the filter. Fuses or Breaker can be installed before the filter based on the real application.
NOTE:
To minimize the interference, the filter must be installed in close proximity to AxN Size4
Drive as much as possible. But, the distance between two devices should also comply with the
Installation Space Regulation of AxN Size4 Drive (Refer to
). The length of
AC power supply cable should
NOT
exceed
0.5m
.
Step 3: Find out the AC Power Input Terminals
PE, T, S and R, these are the four terminals called AC Power Input Terminals. AxN Size4 Drive
’s
AC
Power Input Terminals are in the Power Supply Input Port (P1) which is on the top of the drive.
Refer to the following figures for exact locations and terminal Assignment.
Summary of Contents for AxN 70.140.4
Page 2: ......
Page 7: ...5 1 3 Overall Dimensions...
Page 15: ...13...
Page 34: ...32 When the drive is ready N O connects Com and N C disconnects Com illustrated as below...
