4
LAMP INSTALLATION
NOTE:
Please wear gloves in order to protect the DE lamp envelope from skin oils, which
can be damaging to the lamp.
Do not apply excessive force when installing lamp.
IMPORTANT:
The lamp must be oriented so that the high voltage wire end/lead (the end near
the getter, which is the small square tab attached to the wire loop) is installed in the socket end
closest to the ballast as seen in
DIAGRAM A
.
NOTE:
Lamp shown below is for general reference only; actual lamp included may vary.
DIAGRAM A
1. Before installing the lamp, make sure it is oriented so that the
burner filament (the long wire that runs along the full length of the
arc tube) is positioned upward, facing the top inside surface of the
reflector, as seen in
DIAGRAM A
.
2. Ensure that the wire ends/lead sare not bent or frayed, as this
will prevent proper installation. The wire ends should be straight
as shown in
PHOTOA
.
3. Open both lamp holders by sliding them outwards and away from
the center of the fixture, as shown in
PHOTO B
.
4. Install the double-ended lamp within the lamp holders shown below
in
PHOTOS B, C &D
.
PHOTO A
PHOTO B
PHOTO C
PHOTO D
5. The wire ends/leads must be fully seated as shown (
PHOTOS E & F
) before sliding each
socket end closed.
PHOTO E
PHOTO F
Anode
ArcTube
Quartz Outer Jacket
Cathode
Getter
Burner Filament
