7
ENVIRONMENTAL CONTROLLERS
Note:
Zone A and Zone B
can be set up in one room,
or in two separate rooms.
When setting restrike delays with your environmental controller, it is best to set a restrike delay at 20
minutes or longer to prevent constant restrikes throughout the day.
When installing your controller, it is best to program the controller for a staggered start with 40
luminaires or fewer on each start.
Itis best to us especial HID relays and high in rush circuit breakers to ensure proper
performance. For optimum performance, lighting sub-panels should have a fan installed to
prevent high heat of the sub-panel.
AUTOPILOT PX2 CONTROLLER
NOTE:
Phantom LP system uses ANALOG 0–11.5V control protocol.
Please ensure you select
ANALOG
when using with compatible PX series controllers.
The Autopilot PX2 Controller is designed to work with the Phantom Commercial DE Electronic
Ballast.FollowthePX2Controllerinstructionsforproperoperationandtoavoidballastdamage.
Typical setup for the PX2 Digital Lighting Controller is shown below.
HID Fixtures
PHANTOM
with RJ PX Port
Fixtures are not shown to scale.
LEGEND:
HPS, MH & CMH
RJ Data Link Cable
RJ Splitter
RJ14 to RJ14
IMPORTANT:
Do not attach datalink cables to AC power cable. Always keep low voltage datacables and high voltage AC
power harness as far as possible from each otherfor stable signal transmission. Avoid coiling data cables as well as AC
harnesses in tight coils. Excess cable should be managed by creating long loops as opposed to tight coils.
Advanced Digital & Analog
Lighting Controller
(APDPX2)
ZONE A
Controls up to
256 HID fixtures.
ZONE B
Controls up to
256 HID fixtures.
