INSTALLATION GUIDE V1.0
FOUNDERS EDITION
GLACIER G2080
PH-GB2080FE_BK01/CR01
PACKAGE CONTENTS
WARNING
-
This product is intended for advanced users. Improper installation may result in damage to your equipment. While all efforts
have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s)
occurring to your components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below
instructions, or due to failure or defect in the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
Turn off the power to your system and discharge your body’s static electric charge before proceeding with the installation procedure. If you do not
feel comfortable with performing the installation procedure, consult a qualified computer technician.
For latest version check www.Phanteks.com
STEP 1. REMOVING STOCK COOLER
GLACIER GB2080FE
QTY: 1
GLACIER Stop Fitting
QTY: 2
Thermal Pads
QTY: 2
M2,5x5 Screws
QTY: 15
Washers
QTY: 15
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks RGB Cable
QTY: 1
RGB Motherboard
Adapter
QTY: 1
Unscrew all highlighted screws to remove
the backplate and stock cooler.
STEP 2. APPLYING THERMAL COMPOUND
Clean off the original thermal compound.
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
Use the EVA-Foam from the box to use
as a base for your installation process.
