GSPublisherVersion 183.1.8.100
2
TOOLS REQUIRED
Screw Driver
(Pozidriv Head)
Cordless Drill
Pozi Bit (PZ2)
1. Confirm that all panels (6) are in the package before assembling.
2. Check the white sticker on each panel for the labelling (A, B, C, D, E & F).
3. Ensure that the panels are laid on a non-abrasive surface when assembling.
4. Note that all panel connections are done using the system described below.
Rubber Mallet
8mm Drill Bit
2 O'Clock
Position
230°
PANEL CONNECTION AND FASTENING
GENERAL INSTRUCTIONS
Det. 1
Det. 2
Det. 3
I
II
III
IV
I -
Insert the Minifix (1), Dufix (1) and wooden dowels (2) in the shown positions.
Gently knock in the wooden dowels using a rubber mallet where necessary.
II -
Confirm that the Minifix orientation is as shown in Det. 1 then connect the
panels.
III -
Using a screw driver, turn the Minifix 230° clockwise to fasten the panels
together. Refer to Det. 2.
IV -
See Det. 3 for Minifix orientation when fastened. Reset the Minifix
orientation to that shown in Det.1 to disconnect the panels.
