There is a continuous output button, which can be pressed permanently on and volume can be set at the
desired level.
When the timer button is pressed, the user then gets control over interval (0-30minutes approx.) pot and
duration control pot (0-15 seconds approx.).
The override button will override the continuous and timer settings.
First Time Operation With DMX:
Before you start using this unit, please check for transportation damage, should there be any, please do not
use the device and contact your dealer immediately.
The Stage Mist 800 is designed to be used with water based haze fluid. NEVER OIL BASED.
Put the hazer on a flat stable surface. Make sure no one can put any body part close to the heater output.
Unscrew the lid on the fluid bottle, fill up with a suitable fog liquid, take care not to over fill. Then screw the
plastic cap back on. Make sure the tank never runs dry during operation.
Connect a DMX controller to the DMX input socket. Terminate the output socket or connect to other DMX
fixtures.
This unit takes up two DMX channels fan speed and haze output.
Set the DMX address in the menu, using the menu up & down buttons.
There is some useful DMX info at the end of this manual.
Self-Cleaning Function:
Please do not turn your unit straight off after cleaning. This machine has a self-cleaning function. This pushes air
through the pump and heater to remove any residue of liquid left after use, this will prolong the life of the heater.
If in DMX mode turn the haze output to zero, then turn the power off after about 1 minute 30 seconds.
If using the internal menu, adjust ‘h’ in the menu to zero, then turn power off after 1minute 30 seconds.
If using the timer remote turn the haze output pot to zero then turn off after the 1 minute 30 seconds.
DMX Channel
DMX Value
FUNCTION
Channel 1
000-255
0-100% Fan Speed
Channel 2
000-255
0-100% Fan Speed
DISPLAY
FUNCTION
d001-d512 DMX Address
h 0-5
Output Volume 0=off, 1=Low,
3=High
F 0-5
Fan Speed 1=Slow, 5=Fast
FLASH
Shows when liquid is low
