ENGLISH
ENGLISH
7
8
10
9
12
7 TRIM FLANGE ATTACHMENT
Position Flange (
7A
) onto Valve (
7B
). Place Protective Washer (
7C
) on the short end
of the reversible Retainer Sleeve (
7D
). Screw Retainer Sleeve (
7D
) onto threaded
section of Valve (
7B
). Tighten Retainer Sleeve (
7D
) by hand until Flange (
7A
) is snug to
finished wall surface. If the short end of the Retainer Sleeve (
7D
) is too short, reverse
it to use the longer end.
8 HANDLE ATTACHMENT
Thread Set Screw (
8C
) into Handle (
8D
) and thread it in only three to four turns. Place
Handle (
8D
) onto the SValve Stem (
8B
) and tighten Set Screw (
8C
) by using the Hex
Wrench (
8E
) that is provided.
Make sure Set Screw (
8C
) is securely tightened to Handle (
8D
).
9 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (
9A
) from Wall Mount (
9B
). Use Wall Mount Screw Holes (
9C
) to
place the desired location. Using a punch or awl, tap the screw hole locations. Holes
must be vertically aligned.
10 ANCHOR INSTALLATION
Drill two
1
/
4
” Dia. Holes (
10A
). If installing into a stud, drill two
1
/
8
” Dia. holes and do
not use Anchors (
10B
). Insert Anchors (
10B
) into Holes (
10A
) and tap flush with wall.
11 WALL MOUNT INSTALLATION
Place Wall Mount (
11A
) onto wall and insert Mounting Screws (
11B
) through Wall Mount
Holes (
11C
) and tighten until Wall Mount (
11A
) is flush with the wall.
Do Not Over
Tighten!
Insert Front Cover (
11D
) into Wall Mount (
11A
).
12 DROP ELBOW & HOSE INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (
12A
) (
not included
). Screw Pipe
Niple (
12A
) into the elbow inside the wall. The Pipe Niple (
12A
) is to project
1
/
4
"-
3
/
8
"
from the finished wall. Screw Drop Elbow (
12B
) onto Pipe Niple (
12A
) and tighten until
Drop Elbow (
12B
) is properly positioned and flush to the finished wall.
Place Rubber Seal (
12C
) inside Hex Hose Fitting (
12D
). Connect Hex Hose Fitting (
12D
)
into
Drop Elbow Outlet (
12E
)
by turning Hex Hose Fitting (
12D
).
11
3
7A
7B
9A
9B
9B
7D
8B
8C
8E
8D
7C
9C
10A
10B
3/4”
11A
11D
11B
11C
11C
11B
12A
12B
12C
12E
12D
1
/
4"-3
/
8"
Summary of Contents for KENZO 16 Series
Page 11: ...FRANÇAIS FRANÇAIS 11 ...
