ENGLISH
ENGLISH
4
2
3
FAUCET INSTALLATION
5
5 CONNECTING AND SECURING HOSE GUIDE
Apply a small bead of plumber’s putty (make sure to follow manufacturer’s
recommendations on use) to bottom inside edge of Hose Guide (
5A
). Mount Hose Guide
(
5A
) in far right hole in sink (
5B
). Secure Hose Guide using Locknut (
5C
). Hand tighten.
5C
5A
5B
7
7A
7B
7C
7D
7E
7E
Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING:
Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Plumber's putty
• Slotted screwdriver
• Phillips head screwdriver
• Pliers
• Adjustable wrench
• Flashlight
• Cloth
Your installation may require supply lines and/or shut-off valves, or other additional tools.
Consult the store where your faucet was purchased for recommended connections that
may be required for your area.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included:
A
Faucet Body
B
Handles (2x)
C
Side Spray
D
Hose Guide with Flange
E
Locknuts (3x)
I
f any of these items are missing, please contact Pfister Consumer Services at
1-800-Pfaucet (1-800-732-8238).
7 HOSE ATTACHMENT
Apply PTFE plumber’s tape to all threaded fittings according to manufacturer’s
instructions. Carefully tighten the Side Spray Hose (
7A
) to the Spray Supply Tube
(
7B
) located on the bottom of the Faucet Body (
7C
).
Following manufacturer’s
recommendations on use, apply plumber’s putty into putty groove in bottom plate (
7D
).
Insert faucet Shanks (
7E
) through the holes of the sink.
3
A
B
B
C
D
E
E
E
6 SIDE SPRAY INSTALLATION
Insert the Side Spray Hose (
6A
) through the Hose Guide (
6B
). From underneath sink, feed
the Side Spray Hose (
6A
) back up through the center hole of sink so that it is above the sink.
6A
6B
6
