18
Installation
Connect the transmitter appropriately (see operating instruction of the ActiveLine trans-
mitter).
Open the cover of the casing for electronics.
Run the measuring cable into the casing for electronics from below.
Plug the measuring cable in the connection X3 of the DCU.
Settings are possible with the extended parameter set at the DCU.
5.9
Connecting to the mains power supply
Observe the information on the rating plae.
Plug the mains cable into the the mains connection on the rear side of the pumping
station and fix it with the clip.
Connect the mains cable to the mains.
Fig. 7:
HiCube Pro, running a measuring cable
2
Display and control unit
2.1
Measuring gauge
2.4
Measuring cable
89
Control casing
2
89
2.1
2.4
WARNING
Danger of unsafe electrical installation
Safe operation after installation is the responsibility of the operator.
Do not independently modify or change the pump and electrical equipment.
Make sure that the system is integrated in an emergency off safety circuit.
Consult Pfeiffer Vacuum for special requirements.
