Pfaff hobbylock 2.0, Owner'S Manual, Page: 6 / 28

6
A
A
Setting up the telescopic thread stand
Pull out the spool stand in the direction of the arrow (A)
Extend the telescopic thread stand to its full height, then turn
until it clicks into place.
Place the thread spools or cones over the cone holders on the
spool pin.
If the machine is already threaded, straighten the threads to
prevent tangling.
Attaching the waste tray
Position the machine so the front is nearly aligned with the edge
of the table. Insert the U-shaped hooks of the waste tray onto
the two suction cups on the underside of the machine. Make
sure the trimmed fabric falls into the net bag while sewing.
Opening and closing front cover
Open the front cover
First push the cover to the right as far as it will go and then pull
it downward toward you.
Close the front cover
First pull the cover upward and then slide it to the left until it
locks.
Note: The front cover has a safety switch and the machine will
not sew if the front cover is open.
Removing and replacing the Á at bed
extension
Free arm sewing
For a free arm machine, slide off the Á at bed extension. The free
arm makes it easier to sew small items and hard to reach areas
such as armholes and overcasting trouser cuffs.
To remove the Á at bed extension
Slide the Á at bed extension to the left and remove it from the
machine while pulling the release (A) located on the underside.
To replace the Á at bed extension
Align the projection on the Á at bed extension with the groove
on the back of the free arm and slide it to the right until it snaps
into place.