21
1
2
3
Replacing the stationary cutter
Turn off the main power switch and unplug the machine.
The stationary cutter should be changed when it becomes dull.
The stationary cutter can be replaced according to the following
directions. If you are having any dif
À
culties, consult your dealer
to make the necessary adjustments.
1. Open the front cover and set the movable upper cutter (1) in
nonworking position.
2. Loosen the stationary cutter set screw (2) and remove the
stationary cutter (3).
3. Place a new stationary cutter in the groove of the stationary
cutter holder.
4. Tighten the stationary cutter set screw (2).
5. Return the movable upper cutter (1) to its working position.
6. Turn the handwheel so the needles are in their lowest
position.
7. Make sure the front edge of the movable upper cutter is 1-2
mm lower than the cutting edge of the stationary cutter.
Storage
When the machine is not in use, be sure to keep it unplugged.
Cover the machine with the vinyl cover to protect it from the
dust. Store the machine, so it is not exposed to direct sunlight or
humidity.
Servicing
If you have any questions regarding service and/or operation,
contact the store where the machine was purchased.
Summary of Contents for hobbylock 2.0
Page 1: ...O w n e r s M a n u a l...