Pfaff hobbylock 2.0, Owner'S Manual, Page: 11 / 28

11
1
3
2
4
5
6
7
8
10
9
10
9A 9B
Threading the lower looper (yellow)
1. Pass the thread from back to front through the thread guide
on the thread stand (1).
2. Pull the thread from left to right under the thread guide on
the back of the top cover (2).
3. Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between the
tension discs and pull it down to make certain it is properly
placed between the tension discs (3).
4. Turn the hand wheel toward you until the lower looper is at
the far right.
5. Thread the looper area of the machine following the yellow
color coded thread guides (4-8). Use the tweezers to make
the threading easier.
6. Pass the thread behind and over the tip of the lower looper
(9A). Then pull it gently to the left until it will slip into the
slot in the lower looper (9B).
7. Pick up the thread and pass it through the hole of the lower
looper (10). The thread should be positioned in the groove
of the lower looper.
8. Pull about 10 cm of thread through the looper and place it
over the upper looper and to the back of the stitch plate.