(E)
(G)
(H)
(P)
(K)
(S)
(L)
(M)
(A)
(B)
(C)
(D)
104 72 63-26
7
Replacing and Adjusting Needle threader
Requirement
When the needle threader is at its threading position, the treader hook must pass through a size 70 needle eye
without hitting on top or bottom of the needle eye and have the same distance either to the left or to the right
side of the needle eye.
Replacing the needle threader
• Remove the face plate.
• Pull the threader (A) out from the threader shaft (B)
• Take the new needle treader and align the groove (C)
with the pin (D) on the threader shaft.
• Push the threader up until it snaps in place.
Adjustment sideways
• If the threader hook (E) hits against either left or right
edge of the needle eye (G).
• Loosen the setscrew (H).
• Move the threader plate (K) to adjust the sideways
position of the threader hook.
• Tighten the setscrew (H)
Adjustment High ways
• If the threader hook (L) hits against either top or bot-
tom edge of the needle eye (M) or misses the needle
eye (M)
• Loosen the setscrew (P) Move the threader position
setting plate (S) up or down to adjust the vertical posi-
tion of the threader hook (L).