(A)
(B)
(C)
(E)
(D)
(G)
10.5 mm
104 72 63-26
25
Adjustment of the thread drawing lever
Requirement
When the needle point is 10.5 mm above the needle plate, com-
ing from its lowest turning position, and the solenoid disk (C)
fully closed, then should the tip of the thread drawing lever (G)
lightly makes contact with the bobbin.
Check
• Remove the base.
• Turn the hand wheel in the sewing direction from it’s lowest turn-
ing position until the needle point is 10.5 mm above the upper
surface of the needle plate.
• At this point push the solenoid disk (C) so it closes fully and
that the tip of the thread drawing lever (G) lightly makes contact
with the bobbin.
Adjustment
• Remove the base.
• Loosen the setscrew (A) so the stopper (B) is loose.
• Turn the hand wheel in the sewing direction from it’s lowest turn-
ing position until the needle point is 10.5 mm above the upper
surface of the needle plate.
• At this point push the solenoid disk (C) so it closes fully and that
the tip of the thread drawing lever (G) lightly makes contact with
the bobbin. If NOT.
• Loosen the setscrew (E) and move the thread drawing arm (D)
to the left or right so that the tip of the thread drawing lever (G)
lightly contacts with the bobbin.
• Tighten the setscrew (E).
• Push one more time the solenoid disk (C) so it closes and that
the tip of the thread drawing lever (G) lightly contacts with the
bobbin.
• Push stopper (B) against the thread drawing lever (D) still with
the solenoid disc (C) closed.
• Tighten the setscrew (A) fi rmly.
• Attach the base.