Pfaff creative sensation, Owner'S Manual, Page: 33 / 164

2:11
B
E
D
C
1
E
2
D
3
Pr
epar
ations
Changing the presser foot
Remove presser foot
Press the presser foot downwards until it
disengages from the presser foot holder.
Attach presser foot
Line up the pins on the foot with the gap
underneath the presser foot holder. Press upwards
until the foot snaps into place.
You can also use the presser foot up/down buttons
to raise or lower the presser foot holder. Place the
presser foot under the presser foot holder, so that
the pins of the foot snap onto the presser foot holder
when lowered.
Attaching the Dynamic spring foot
6D
1. Disengage the IDT™ system (B). Remove the
standard presser foot (C). Carefully loosen the
screw (D) until the cross-hole (E) is accessible.
2. Squeeze the embroidery foot gently together
and guide the pin of the foot into the cross-hole
(E) of the presser foot holder as far as it will go.
The arm on the foot should be placed behind
the needle screw.
3. Tighten the screw (D).
To remove the embroidery foot loosen the screw
(D), squeeze the embroidery foot together and pull
it out to the right. Tighten the screw (D).