Pfaff creative 1.5, Owner'S Manual, Page: 53 / 68

Embro
idering
Orbit to Check Position
Stitch-out view 2
Orbiting can be used to trace the design area. Press the
first row + button to move the hoop so the needle is
placed in the upper left corner of where the design will
be embroidered. Each time you press the + button the
hoop will move to view all corners of the design. On the
fifth press the hoop will move so the needle is above the
center position of the design. On the sixth press it will
move back to its original position. If the - button is
pressed the hoop will move in reverse sequence. The
hoop will first move to the center position of the design
and then to each corner.
Basting
Stitch-out view 2
Press the second row - or + button and the machine will
create a basting stitch around the design area.
Basting enables you to secure your fabric to a stabilizer
placed beneath it, especially when the fabric to be
embroidered cannot be hooped. Basting provides
support for stretchy fabrics. It also shows where the
design will be placed on the fabric.
Note: During basting the design box will be indicated with a
dashed line.
Monochrome
Stitch-out view 2
Press the third row - or + buttons to activate
monochrome embroidery. The machine will not stop for
color block changes. Press the button again to deactivate
monochrome embroidery.
Note: When monochrome is activated, the design box will be
indicated with a black frame.
Speed Control
Adjust the maximum embroidery speed by sliding the
speed control lever up or down. It works just like in
sewing mode, see page 29.
Thread Tension
When embroidering with specialty thread or fabric you
may need to adjust the thread tension to achieve the
best result. Thread tension can be adjusted in the
settings menu, see page 30.
53