Adjustment
14 - 4
Fine adjustment
●
Switch on the machine.
●
In the input mode, select parameter
"608"
, see
Chapter 11.03 Parameter input
in the
instruction manual.
●
If necessary, enter the access code, see
Chapter 11.04.01 Entering the access code
in
the instruction manual.
●
With the corresponding
plus/minus key
move the work clamp drive unit in accordance
with
requirement 1
, also see
Chapter 11.03 Parameter input
.
●
Switch off the machine.
●
Remove adjustment gauge
1.
●
Fit the lower feed plate and work clamp holder.
If, during the fine adjustment, the setting is
± 5
increments above or below the
value in
X-
and
Y-direction
, the setting should be checked again in accordance
with
requirement 2
.
Summary of Contents for 3371-1 series
