PEUGEOT PARS, Owner'S Manual

Page: 54 / 151

53
2
AUDIO SYSTEM
ANTI-THEFT SYSTEM OF THE AUDIO
SYSTEM
How to enter the password
For more security, your device is equipped with
4 digit code. In case of electrical disconnection
of the device for any reason and, after
reconnecting and turning on the device, the
monitor displays the phrase “PWD****”. To turn
on the device, the correct 4 digit code should
be entered through the buttons 1 to 4 on the
panel.
To enter the 1st No. from the left side of
(****PWD), press the radio button No. 1
frequently to display the correct number. (For
example: For selection the No.5, press the
button No. 1, 5 times. After correct adjusting
of the first number, to enter the 2nd number
of (****PWD), press the radio button No. 2
frequently to display the correct number. To
enter 3rd and 4th Nos. press the same buttons
as previous ones. To confirm the password,
press the SETUP/AUDIO button. In case of
the correct password, the device turns on;
otherwise, displays (Error). After short seconds,
the system requests the password again on
which entering the correct password, the
device is turned on. If the incorrect password
is entered for six times, ERR20 is displayed
on panel which is indicating the blockage of
the system. Here, you should refer to the Iran
Khodre authorized dealers.
Note: The default password by Iran Khodro is
1111.
CHANGING THE PASSWORD
Whereas, the default password before
changing is considered 1111 by Iran Khodro,
it is better changing it for more security. To
change the password, hold the “RADIO” and
“RPT/1 buttons for 2 seconds simultaneously.
The “****PWD” message demands the
adjusted password. In case of entering the
correct 4 digit password, the “****PWD”
message is displayed to enter the new 4 digit
password. Enter the new code and press the
SETUP/AUDIO button. Now, the “****PWD”
message demands again the new 4 digit
password for comparing. Select the previous
new 4 digit code and press the SETUP/AUDIO
volume button. If the entered password are
matched, the “****PWD” message is displayed
and means that the password has been
changed. While the 2 entered password is not
the same, the “SETFAIL” message is displayed
and it means there is an error in changing the
password. Now, all the changing process
should be repeated again.