CELL DISCHARGE BENCH USER INSTRUCTIONS
Page: 18
Reproductions or translations, even parrtial, are forbidden without the written consent of Peugeot Motocycles
6Volt BATTERY CELL DISCHARGE BENCH INSTRUCTIONS FOR USE
Characteristics:
Operating voltage 6 Volts
Discharge current 100 amperes
Ventilated discharger
Presentation:
Liquid crystal display (A) on front panel
Fan (B) at rear
2 connection cables (C) + red wire / - blue wire
Protection:
Against polarity inversions (display off)
Against connection of cells in series (display off)
Heat protection, discharge stopped temporarily
(display flashes)
Instructions for use:
Disconnect and remove the 3 cells
Connect the cell to the discharge bench
- Red wire to the cell + terminal
- Blue wire to the cell - terminal
Tighten the terminals, the cell voltage is displayed
The cooling fan (B) runs (if the voltage is between 7.5 V and 4.5 V)
The cell discharges automatically
When discharge is finished, the fan stops and the discharge time is displayed in minutes on the display (A)
(e.g.: T=50)
Battery cell discharge:
On reception of a new uncharged cell
The other 2 cells must be discharged, one after the other in order to equalise and have the same voltage as
the new cell.
After refitting the cells, carry out the battery replacement procedures on the TEP96 and commissioning the
battery with the TEP96 (see corresponding chapters).
Precautions:
Do not use the discharge bench with batteries from another source
Do not splash water, petrol or oil on the discharge bench
Keep the discharge bench away from inflammable materials
