i
125
BONNET
Protects the components of the engine
and provides access for checking levels.
Push the exterior control
B
to the left
and raise the bonnet.
Unclip the strut
C
from its housing .
Fix the strut in one of the two notches
to hold the bonnet open.
Closing
Take the strut out of the support
notch.
Clip the strut in its housing.
Lower the bonnet and release it at
the end of its travel.
Pull on the bonnet to check that it is
secured correctly.
RUNNING OUT OF FUEL
(DIESEL)
If your vehicle is fi tted with an HDI en-
gine, the fuel circuit must be reprimed
if you run out of fuel (refer to the corre-
sponding graphic).
This system consists of a repriming
pump and a transparent pipe.
Opening
Open the front left door.
Pull the interior control
A
, located at
the bottom of the door frame.
The location of the interior control
prevents opening of the bonnet
while the front left door is closed.
1.4 litre Turbo HDI engine
Open the bonnet.
Fill the fuel tank with at least fi ve li-
tres of diesel.
Squeeze and release the repriming
pump until fuel appears in the trans-
parent pipe.
Operate the starter until the engine
starts.
Close the bonnet.
1.6 litre Turbo HDI 16V engine
Open the bonnet.
Fill the fuel tank with at least fi ve litres
of diesel.
Unclip the style cover to gain access
to the repriming pump.
Squeeze and release the repriming
pump until fuel appears in the trans-
parent pipe with the green connector.
Operate the starter until the engine
starts.
Put the style cover back in position
and clip it in place.
Close the bonnet.
