www.petsafe.net
3
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
1. Remove the screws with a Phillips screwdriver.
2. Remove the Battery Lid (
1B
).
3. Install a 9-volt alkaline battery (
1C
).
4. Replace the Battery Lid (
1D
).
5. Reinstall the screws. Do not over-tighten the screws.
Replacement 9-volt alkaline batteries can be found at many retailers.
1B
1C
1A
To Change the Mode
Read all the steps before attempting to
change the mode.
1. With the battery installed, press the
Mode Button and release it when the
Receiver Indicator Light lights up (
1E
).
2. The Receiver Indicator Light will emit a
number of flashes representing the mode
setting (
1F
).
3. Change the mode by pressing and
releasing the Mode Button within
5 seconds of the previous flashes.
1D
1E
1F
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for
pets with long or thick hair. Using the Test Light Tool, tighten the Contact Points one-quarter to
one-half turn beyond finger tight (
1A
). Check the tightness weekly.
